Coral Placement in a Reef Tank
Share
Quick answer
For coral placement in a reef tank, match each coral to its light and flow. Reef sources put SPS corals near the top where light and flow are strong, LPS corals in the middle, and soft corals low where both are gentler. Leave room to grow, and move corals as little as you can.
| Who | Reef keepers adding new corals, or fixing a tank where some corals struggle. |
|---|---|
| What | Choosing a spot for each coral based on light, flow, spacing and how it grows. |
| When | Before you glue or set a coral down, and again each time you add one. |
| Where | High on the rockwork for strong light and flow, low or under overhangs for gentler spots. |
| Why | A coral in the wrong zone can fade, shrink or get stung by a neighbor, and moving it costs it time. |
Coral placement in a reef tank: light zones
Start with your light, not your corals. Bulk Reef Supply says a PAR meter is "the ONLY way to know for certain" how much light a coral gets. It also says to set your lighting first and then buy corals that fit, since the light output of a given setup is fixed once you choose it.
Once you know your light, think in height. Bulk Reef Supply says higher rock placement generally means more light and stronger flow, and mid and lower areas get less of both. Reef Builders agrees: SPS corals come from high-energy reef areas and do best near the top, where they get high flow and intense light. Soft and LPS corals do better lower down or under overhangs.
Reef Builders also wrote a guide that sorts zones by light type:
- LED: SPS near the top, LPS in the middle (with some exceptions), soft corals at the bottom. LEDs are usually dimmable, so you can tune intensity.
- T5: SPS closest to the light, LPS in the middle, soft corals near the bottom.
- Metal halide: SPS in the middle to top, LPS and soft corals at the bottom. These lights are strong, so watch for burned corals.
- Compact fluorescent: LPS on top and soft corals elsewhere. The author says to keep SPS out of these tanks.
Flow zones
Bulk Reef Supply sorts flow into low, medium and high. Corals from the reef top face stronger waves and currents. Corals on the seafloor or in crevices get more shelter. Match each coral to its zone. Delicate corals like mushrooms often want calmer water, as our mushroom coral care guide explains. Pump layout also changes flow, so see powerhead placement.
Spacing and growth
- Give each coral room. Reef Builders says corals compete for space, so each needs room to grow, even if a new tank looks bare. Without it, growth may slow or an aggressive neighbor may kill others.
- Watch for shade. Table Acropora and plating Montipora grow fast and shade what is below. Reef Builders says to place them low and not above slow growers.
- Put tall growers at the back or sides. Staghorn Acropora, some leather corals and Sinularia grow tall.
- Keep aggressive neighbors apart. Bulk Reef Supply says to keep corals away from aggressive sweeper tentacles and avoid placing LPS and SPS side by side.
- Plan colors. Both sources suggest blending colors and types instead of grouping one kind in a patch.
How to add a new coral
Reef Builders says to start corals under lower light and move them gradually to their final spot. That matters most under strong light. It also says frags tolerate small changes better than large colonies, but moving any coral can take two to three months at a minimum to adjust. Make a diagram first, using color, growth rate, aggressiveness and type. Then start with a few frags to confirm your conditions work.
For gluing, Bulk Reef Supply prefers cyanoacrylate gel because it cures underwater. Turn off pumps and the skimmer while you work. See how to mount coral for the full steps.
Using racks and frag heads
Magnetic racks and frag heads hold frags in place. The product pages describe what each one does.
The Nexus Single Magnetic Frag Rack holds a single plug. The page calls it ideal for showing off a prized frag or testing a new coral before you add it to your main rack. It says the magnetic mount holds firmly through glass or acrylic and that the plug system locks frag plugs in place, preventing movement from strong flow.
The L-Rack is a magnetic corner frag rack. Its page says strong magnets keep it locked in place, even in high-flow areas, and gives its size as 8.5 inches on the long side by 5.5 inches on the short side. It also says standard magnets are good up to 1/2 inch glass or acrylic, and that for 3/4 inch and up it recommends the More Magnets option. Browse the full Nexus magnetic racks collection, and our guide to aquascaping with magnetic frag mounts covers layouts.
For single frags, frag heads are another choice. Curvy Girl is described as great for encrusting coral or a show piece. Trooper is a frag holder. Shredder is a frag head with sealed magnets that the page says is compatible with most standard frag plugs.
If your tank does not use magnets, the Nexus Coral Sphere page says it is non-magnetic, holds 10 standard frag plugs and sits on rock or substrate.
Mistakes to avoid
- Buying before you know your light. Set up light first, then pick corals to match.
- Crowding a new tank. It looks bare now, but corals need room.
- Putting a fast grower over a slow one. Plating and branching corals shade what is below.
- Moving corals again and again. Each move can mean another adjustment period.
Questions people ask
Where do SPS corals go in a reef tank?
Near the top, where light and flow are strongest, according to Reef Builders and Bulk Reef Supply.
Where do soft corals go?
Lower in the tank, where light and flow are gentler. Bulk Reef Supply says soft corals suit the bottom.
How much space should I leave between corals?
Neither source gives one number. Both say to leave room for growth, and more room for fast growers.
Can I put LPS next to SPS?
Bulk Reef Supply says to avoid placing LPS and SPS side by side.
How long does a coral take to adjust after a move?
Reef Builders says two to three months at a minimum for any coral.
Gear for this job
Magnetic racks and frag heads
Hold a frag in the spot you chose. Each product page lists how it mounts and which plugs it takes.
Shop Nexus magnetic racksKeep reading: Aquascaping with Magnetic Frag Mounts · Mushroom Coral Care · Frag Tank Setup




